The Complete Guide to Using Angelwax Fastfoam

What Angelwax Fastfoam is designed to do

Angelwax Fastfoam is used after the initial pre-wash stage and is designed to remove remaining surface dirt before the contact wash.

It works by lifting and loosening contamination so it can be rinsed away without touching the paint.

This reduces the amount of dirt left on the surface and makes the contact wash safer.

Why Fastfoam is important

Even after using Angelwax Cleanliness, there will still be contamination on the surface.

Going straight into a contact wash at this stage increases the risk of dragging dirt across the paint.

Angelwax Fastfoam reduces that risk by removing as much of the remaining contamination as possible before any physical contact is made.

When to use Angelwax Fastfoam

Fastfoam should be used as part of every proper wash following Angelwax Cleanliness.

It is particularly important when:
The vehicle is visibly dirty
You want to minimise the risk of swirl marks
You are preparing the car for further detailing

Used regularly, it helps maintain a safer and more consistent wash process.

How to use Angelwax Fastfoam properly

After rinsing off Angelwax Cleanliness, prepare your foam lance with Angelwax Fastfoam using the correct dilution.

Apply the foam across the entire vehicle, ensuring full and even coverage.

Allow it to dwell for five to ten minutes so it can lift dirt from the surface.

Do not allow the foam to dry.

Rinse thoroughly from top to bottom using a pressure washer.

What Fastfoam does and does not do

Fastfoam removes loose and surface-level contamination.

It does not replace shampoo and it does not remove bonded contamination such as tar or iron fallout.

Its role is to prepare the vehicle for the contact wash and reduce the risk of damage.

Common mistakes to avoid

Applying to a hot surface
Allowing the foam to dry
Using incorrect dilution
Rushing the dwell time

Each of these reduces performance.

How it fits into the wash process

Angelwax Fastfoam sits between Cleanliness and the contact wash.

The process is:
Cleanliness
Fastfoam
Wheel and tyre cleaning
Contact wash using Angelwax shampoo, buckets and Wash Mitt
Rinse
Blue Rinse
Drying with an Angelwax Drying Towel

Using Fastfoam correctly improves the safety and effectiveness of every stage that follows.

Using Fastfoam with the Angelwax Blizzard foam lance

To get the best performance from Angelwax Fastfoam, it should be applied using the Angelwax Blizzard foam lance.

The Angelwax Blizzard ensures consistent coverage, proper foam thickness and the correct dwell time across the entire vehicle.

This guide to using the Angelwax Blizzard foam lance explains how to set it up, adjust it correctly and apply Fastfoam for the best possible results.