The Complete Guide to Using Angelwax Dreamcoat Spray On Rinse Off SiO2 Coating

What Angelwax Dreamcoat Spray On Rinse Off SiO2 Coating is designed to do

Angelwax Dreamcoat is designed to provide fast, effective protection to your vehicle’s exterior using a simple spray-on, rinse-off application.

It forms a durable SiO₂-based protective layer that enhances gloss while delivering strong hydrophobic properties, causing water to bead and sheet away from the surface.

The coating also offers chemical resistance and helps protect a wide range of surfaces including paintwork, glass, plastic, rubber and trim.

Why paint protection matters

Your vehicle’s exterior is constantly exposed to contamination such as road grime, traffic film, bird droppings and environmental fallout.

Without protection, these contaminants can bond to the surface, making cleaning more difficult and increasing the risk of long-term damage.

A protective coating reduces how strongly dirt adheres, improves water behaviour and helps maintain a cleaner, glossier finish.

When to use Angelwax Dreamcoat

Dreamcoat should be applied after the vehicle has been thoroughly washed and rinsed.

This means after:

Angelwax Cleanliness
Angelwax Fastfoam applied with the Blizzard foam lance
Wheel cleaning using Angelwax Superior Wheel Cleaner
Full wash using Angelwax shampoo, buckets and the Wash Mitt
Final rinse

Unlike traditional protection products, Dreamcoat is applied while the vehicle is still wet.

How to use Angelwax Dreamcoat properly

Ensure the vehicle is clean, wet and cool to the touch before application.

Working one panel at a time, lightly spray Angelwax Dreamcoat directly onto the surface.

Immediately rinse the panel thoroughly with clean water.

Continue this process around the entire vehicle, ensuring the product does not dwell or dry on the surface.

Once complete, dry the vehicle using a suitable drying towel and lightly buff if required.

Application can also be carried out using a foam lance with the correct dilution.

What to expect after application

Once applied, the vehicle will have a highly hydrophobic and protected surface.

You can expect:

Strong water beading and sheeting
Enhanced gloss and finish
Reduced dirt adhesion
Easier maintenance between washes

The self-cleaning effect helps keep the vehicle cleaner for longer and reduces effort during future washes.

How often to apply

Protection typically lasts for several months, depending on driving conditions and maintenance routines.

Vehicles exposed to harsher environments or frequent use may benefit from more regular application.

Routine washing will help maintain performance and extend durability.

Common mistakes to avoid

Applying to a dry surface
Allowing the product to dwell or dry
Applying to hot panels
Using too much product
Trying to coat the entire vehicle at once

Each of these can affect performance and lead to uneven results.

How it fits into the wash process

Angelwax Dreamcoat is applied immediately after washing and rinsing, before the drying stage.

It replaces traditional wax or sealant steps with a faster, more efficient protection method.

Preparing your vehicle properly

For best results, the surface should always be fully cleaned before applying Dreamcoat.

Removing dirt and contamination ensures the coating bonds effectively and delivers consistent performance.